Last DSIRE Review: 08/08/2012
||Utility Rebate Program
|Eligible Efficiency Technologies:
||Equipment Insulation, Water Heaters, Furnaces , Boilers, Compressed air, Programmable Thermostats, Energy Mgmt. Systems/Building Controls, Caulking/Weather-stripping, Building Insulation, Processing and Manufacturing Equipment, Comprehensive Measures/Whole Building, Custom/Others pending approval, Energy Surveys, Infrared Unit Heater, Combustion Tune-Up
|Amount:||Small Business Energy Surveys: Free|
Small Business Equipment Upgrades: up to 70% of cost
Large Commercial Energy Study: 50% of the cost
Custom: $1/therm at less than 20% savings; $2/therm at greater than 20% savings
Control/Automation Systems: $2/therm saved, up to 50% of cost
Hot Water Boilers: $1000-$15,000
Steam Boilers: $700 or $2/MBH
Boiler Reset Controls: $200
Programmable Thermostat: $30
Infiltration Control Measures: Up to 70% of cost
Furnace or Boiler Clean and Tune: $225
Combustion Tune-up: $400
Infrared Unit Heater: $500
Insulation: $0.01-$0.02 multiplied by R-value increase and sq. ft.
|Maximum Incentive:||Large Commercial Energy Study: $50,000 (gas); $67,000 (combined with electric)|
Hot Water Boilers: $15,000
Steam Boilers: $2,500
|Installation Requirements:||To receive rebate for installation, must be an existing directly metered commercial or industrial building, which pays the System Benefits Charge, and has not received an incentive from NYSERDA or another utility.|
Con Edison offers New York Commercial natural gas customers a rebate program for energy efficient equipment in buildings inside the eligible service area. All equipment must be installed by a participating contractor and installations may be inspected before incentive payments. Customers can schedule an energy efficiency survey to begin the program.
The Commercial and Industrial Equipment Rebate and Commercial and Industrial Custom Efficiency Programs offer incentives to gas customers in good standing who contribute to the system benefits charge (SBC). Incentive payments are limited to a simple payback period of one year for commercial projects and six months for industrial projects. Proposed custom incentive projects will be required to pass a cost-effectiveness test.
In May 2011, Con Edison Company began to provide financial incentives for energy efficiency specifically to defer or avoid transmission and distribution capital expenditures. This targeted demand side management program provides financial incentives to demand side management providers, and was approved up to $25 million a year for four years with the goal of attaining 100 MWs of permanent load reduction. Contact Con Edison for additional information on these programs.
Con Edison Commercial|
Commercial and Industrial Energy Efficiency Program
880 Third Avenue, 9th Floor
c/o Lockheed Martin
New York, NY 10022
Phone: (877) 797-6347
Phone 2: (646) 833-1047
Fax: (646) 833-1046